Mold Testing, Removal Remediation,Inspection
Bathroom Mold Testing Staten Island NYBathroom Mold Inspection Staten Island NYMold Removal, Testing, Richmond County NY

Bathroom Mold Removal Staten Island NY



Mold Testing, Remediation, Richmond County NY



There are many reasons why you may experience the need for a bathroom mold remediation in Staten Island NY. Since water is regularly used and people shower and bathe they are often times damp and humid from the use of hot water. Generally mold needs two things to grow. The first is a food source. The second thing is moisture. Therefore damp humid bathrooms are an ideal location for the need for mold removal in Staten Island, NY. Furthermore, when bathroom exhaust vents are not utilized or worse they are broken, this moisture and humidity will be trapped within the room causing mold to begin forming. Once this occurs, it will continue to grow and spread each time you repeat the conditions by showering or bathing. Bathroom mold testing in Staten Island NY homes is needed to determine how bad your problem is.

Bathroom Mold Remediation Staten Island NY

As you can see, bathroom mold remediation in Staten Island NY homes is quite common. Bathrooms offer the proper food sources such as sheetrock, wood, grout and in some homes, carpet. As stated above, the most common cause for bathroom mold removal in Staten Island NY is when the occupants neglecting to run the exhaust fan after showering or bathing. One problem is that many bathrooms don't not even have a bathroom exhaust vent installed. This causes the humidity to build up after showering and leaves it with no place to go. Therefore the humidity will remain in the room, fogging up every surface causing the need for a bathroom mold inspection in Staten Island NY. So if you want to avoid the need for Bathroom Mold testing in Staten Island NY, you should make sure you have a fully operational exhaust fan.

Mold Removal Richmond County NY To prevent the need for bathroom mold removal in Staten Island NY
always run your bathroom exhaust fan after showering


Plumbing leaks are yet another common cause for bathroom mold removal in Staten Island NY. Most of the time plumbing leaks will go undetected since they may be located behind closed up walls. These types of leaks are only discovered once mildew begins forming on the walls or other surfaces. At this point you will need bathroom mold testing in Staten Island NY to determine how extreme the problem is.

Bathroom Mold Remediation, Bathroom Mold Testing,
Bathroom Mold Inspection, Bathroom Mold Removal,
Staten Island NY

Bathroom mold remediation in Staten Island NY will depend largely on the severity of the damage and the types of building materials involved. Below is a worst case scenario of a typical bathroom mold removal in Staten Island NY. Bear in mind your problem may not be as severe.

Conduct a thorough bathroom mold inspection in Staten Island NY home.

Take bathroom mold testing in Staten Island NY home to determine the severity of the damage.

Then it will be necessary to fix any plumbing leaks or other causes for the moisture intrusion.

Set up proper containment to prevent the spread of the contaminants to the unaffected areas of the home.

Remove, bag up and dispose of all contaminated sheetrock, tile, insulation or other contaminated materials.

HEPA Vacuum all contaminated wall, floor and ceiling surfaces throughout the bathroom.

Clean all contaminated wall, ceiling and floor surfaces with an EPA registered anti-microbial biocide.

Sand wood framing to remove all imbedded contamination. We often will use an EPA registered mold stain removing chemical as a good alternative.

Re-HEPA Vacuum all wall, floor and ceiling surfaces.

Encapsulate all contaminated bathroom wall, floor and ceiling surfaces with an appropriate EPA registered mold resistant sealant.

If no exhaust fan exists, supply and install one.

Re-Insulate the wall and ceiling cavities.

Re-Sheetrock, tape, spackle, sand, prime and paint with all sheetrock wall surfaces with a mold resistant paint sealant.

Clean and Sanitize the HVAC air duct system. Mold will often times enter the duct work in a home through natural cracks in the system in addition to the furnace area and especially the return vents.

Return after several days to remove the air scrubber(s).

Break down and remove all containment.

Call (718) 504-5510

Bathroom Mold Inspection, Bathroom Mold Testing, Bathroom Mold
Removal, Bathroom Mold Remediation Staten Island NY Since 1995

Since 1995 Absolutely Spotless, Inc. has offered a full range of remediation services to the homeowners of Staten Island NY. These services include Bathroom Mold Inspection Staten Island NY, Bathroom Mold Testing Staten Island NY, Bathroom Mold Removal Staten Island NY, Bathroom Mold Remediation Staten Island NY. We never leave you hanging as we will come out to see you any time of the day or night to help you with your mold related problems. We even answer the telephone when you call us.